A: Resistors are never precise they normally come with 5% tolerance. However if precise tolerance is needed one can purchase a precise resistor down to 0,01% or even lower % but these resistors are special and made special for each application
6.8 ohms is a standard value, and 6.8 is within 0.74% of 6.75. If you need a precise value, use a potentiometer or start playing with resistors, because resistors have tolerance and you will not be able to build an exact 6.75 by just looking at values - you need to measure combinations.
Timing circuits, and any circuit that depends on the resistor value being fairly precise, such as voltage dividers and comparators. Old story....engineers knew that you couldn't pick through a bunch of loose precision resistors to find close tolerance resistors....The manufacurer already took the close precision resistors and sold them separately. This is not so true these days. Even low tolerance resistors might be high precision. Usually the manufacturer will fill the loose precision needs with parts better than required.
To determine how many resistors need to be made to deliver 5,000 resistors, we must consider production losses, defects, or any other factors that affect the final count. For example, if they expect a 10% defect rate, they would need to produce 5,556 resistors (5,000 divided by 0.9). Therefore, the exact number of resistors to be made depends on the anticipated yield or defect rate in the production process.
Shunt resistors are used with ammeters; voltmeters require series resistors.
electical resistance, in turn, defined as the ratio pof the potentail difference between the ends of a conductor. electric divies are made up of a variety of components inclding, for example, transistors, resistors, capacitors and indutors.
To determine if the resistors lie within the tolerance limits, you need to compare the measured resistance values of the resistors with the specified range provided by the tolerance. If the measured resistance values fall within this specified range, then the resistors are within tolerance limits.
There are many resistors, need to know which one and which vehicle you have.
If you need a resistor of a certain value, and you have no resistors with small enough values,you can create the one you need by connecting several of those you have in parallel.The effective net resistance of resistors in parallel is always less than the smallest individual.And the more resistors you add in parallel, the smaller the net effective resistance becomes.
A box of precision resistors where you can dial in the exact resistance you want with dials. Essentially a variable resistor with very precise, discrete, settings.
most of the resistors commonly used are carbon resistors
The total resistance of resistors in series is simply the sum of the resistance values of those resistors. If the resistors are identical, then you can multiply the resistance of one of them by the number of resistors in the circuit.
Film resistors have lower noise than carbon resistors.