If you are using this device to check to see if the circuit is energized or not, it will work fine. The voltage range on this tester can be used from 120 volts up to 600 volts AC and DC. At the 600 volt range the unit can be left on the line for only 10 seconds and then be not used again for five minutes to let the internal solenoid plunger coil cool down.
You have your own answer. It is 1.5 amps.
Be it AC or DC any device who's nameplate reads 10 volts.
IF the manufacturer did not list a rating on the switch for DC then the switch is not approved for the use on DC. Switches rated for AC will not last long used on DC because they do not have the ability to exstinguish the arc across the contacts present with DC.
AC and DC
5 volts Direct Current 600 milliampers
This action takes inverter equipment that is explained in the link below.
No, 1 amp is 1000 milliamp your power supply will only deliver 600 milliamp or .6 of an amp.
Use a full wave bridge rectifier.
600 in Roman numerals = DC
the answer is dc volts are rectified from ac volts and the amperage will be the same unless you account for the slight drop from the rectifier. dc volts from a battery have no relationship to ac volts. you can derive ac volts from a dc source using an inverter.
The most common voltage is 600 Volts DC. However, various voltages have been used. Most newly built light rail lines use 750 Volts DC. Some have used 1200 VDC or 1500 VDC. A few have used AC current.
from the wall it could be 115v ac, or in non American countries that use it 230v ac. internal voltages range from 12v dc, 5v dc, 3.3v dc.
No.
The Roman numeral for 600 is DC.
In Digital multimeter we use 9V Dc battery.
how to use the Clamp-On Meter Model GCM-600 to find the current of a DC power?