There is no 'total voltage' in a three-phase system. There are three line voltages and three phase voltages.
-- The current in each individual resistor is (voltage across the whole circuit) divided by (the resistance of the individual resistor). -- The current in any individual resistor is less than the total current in the circuit. -- The total current in the circuit is the sum of the currents through each individual resistor.
Total voltage output of 5 2v cells connected in series would be 10v
4 amperes. The voltage adds when batteries are connected in series. If they are the same voltage then the voltage doubles. Using Ohm's law: V = I*R with the voltage doubling and resistance being the same you get I = 2V/R and where V/R was your initial current you get I = 2*2ampers = 4 ampreres
A: If you know the total resistance and total voltage then you know total current flow for the circuit, this current will be same for every resistor in series however the voltage drop will change for each resistor . So measuring the voltage drop across the resistor in question and divide by the total current will give you the resistor value.
In a series circuit the total voltage is the sum of the voltage drops across all the component in series. When the voltage drops across each the individual components are added up, they will equal the supply (or applied) voltage.
ohms law calculation for a series circuit - Total Resistance = Total Voltage divided by Total Current
Yes.If you connect the batteries in series the total voltage will be the sum of the voltages of the batteries.For example if you connect a 12 volt battery in series with a 6 volt battery the total voltage will be 18 volts.
The batteries can be connected in parallel or in series. In parallel, good batteries of the same voltage will have a total voltage across them equal to the voltage across one of them. Those batteries in series will have a total voltage equal to the sum of the voltage of each of the batteries.
The total voltage should not change in this case.
ask the battery. Not me
There is no 'total voltage' in a three-phase system. There are three line voltages and three phase voltages.
-- The current in each individual resistor is (voltage across the whole circuit) divided by (the resistance of the individual resistor). -- The current in any individual resistor is less than the total current in the circuit. -- The total current in the circuit is the sum of the currents through each individual resistor.
Total voltage output of 5 2v cells connected in series would be 10v
multiply the total voltage in the circuit by the total amperage
No. The total voltage drop around a series circuit, per Kirchhoff's voltage law, is zero. However, it is true that the total voltage drop of all of the components except the battery is equal and opposite to the voltage drop of the battery.AnswerInterestingly, the formal definition of electromotive force is based on Kirchhoff's Voltage Law: 'A source's electromotive force is equal to the sum of all the voltage drops around a closed loop, including the source's internal voltage drop'.Expressed as per the original answer, we could also say; 'The algebraic sum of a circuit's electromotive force and voltage drops, including the source's internal voltage drop, is zero'.
The induced voltage acts to oppose any change in current that is causing it. So, if the current is increasing, then the induced voltage will act in the opposite direction to the supply voltage; if the current is decreasing, then the induced voltage will act in the same direction as the supply voltage.