Liquid volume readings should be at the bottom of the menicus or at the level of the liquid in the middle of the container. The accuracy of the reading may vary slightly with the viscosity of the liquid and the diameter of the container.
Hello, this link should help to explain (unless i have misinterpreted the question), Its a reading error known as Meniscus, http://faculty.clintoncc.suny.edu/faculty/michael.gregory/files/Bio%20101/Bio%20101%20Lectures/chemistry/meniscus.jpg
To be sure you are able to read consistently and accurately, always read the meniscus at eye level.
When the eyes are above the level of the meniscus, the value read is less than the level reading.
When the eyes are below the level of the meniscus, the value read is more than the level reading.
Your eyes should be at the same level as the meniscus when taking a reading.
To be sure you are able to read consistently and accurately you have to view meniscus at eye level. When the eyes are above the level of the meniscus, the value read is less than the level reading. When the eyes are below the level of the meniscus, the value read is more than the level reading.
All liquids bend light according to their refraction index. Because of this, if the reading is taken above or below the meniscus, the indicator mark may be wrong.
Read the level of the liquid at the mark on the cylinder.
A graduated cylinder or a volumetric flask should be used to make a precise measurement of liquid volume. These tools have calibrated markings on the side that allow for accurate measurements to be made. It is important to ensure that the liquid level is read at eye level to minimize any parallax error.
You should always measure at the lowest part of the meniscus. The meniscus is a slight curvature at the top of a liquid in a container.
1. Look at the liquid at eye level 2. Measure from the meniscus (the curved line at the surface of the liquid) 3. Be sure to measure your intervals (the value of each measurement line on the cylinder)
The liquid molecules are more strongly attracted to the graduated cylinder than to each other. This causes the liquid to rise up on the sides of the graduated cylinder. Therefore it is important to read the line, even with the center of the meniscus, and at the bottom of the meniscus to accurately measure the volume of a liquid in the graduated cylinder. If you are still a bit confused I also found some information at this website: http://chemistry.about.com/od/chemistrylabexperiments/qt/meniscus.htm
Read the level of the liquid at the mark on the cylinder.
This is called parallax error.
A graduated cylinder or a volumetric flask should be used to make a precise measurement of liquid volume. These tools have calibrated markings on the side that allow for accurate measurements to be made. It is important to ensure that the liquid level is read at eye level to minimize any parallax error.
No
You should always measure at the lowest part of the meniscus. The meniscus is a slight curvature at the top of a liquid in a container.
The Torah, when read in the synagogue, is always read from a Torah-scroll. The Prophets are often read from printed volumes, but ideally are read from scrolls. When studying privately, only printed volumes are used.See also:More about Torah-scrolls
there are 6 volumes is dakishmete noir.you can also read it on ten manga.
First, to insure greatest accuracy, one should make sure conditions are appropriate for the use of the cylinder, meaning that most graduated cylinders are calibrated for use with water at 20 degrees Celsius. One can determine this by looking for "20° TC" or "20° TD" marked on the cylinder. "TC", or "to contain", means that the volume of liquid contained in the cylinder is what is indicated by the graduated markings. "TD", or "to deliver", means the volume of liquid indicated by the markings is what will be delivered when the liquid is dispensed. This difference exists because when liquid is dispensed from any glassware a small amount remains and "TD" takes this difference into account.Second, the liquid should be poured into the cylinder carefully down one side, tilting the cylinder to minimize splashing and the formation of bubbles.Finally, to read the liquid volume, the cylinder should be on a level surface and the liquid level read at the bottom of the meniscus at eye level.
You should be able to find it on manga2u.com. If not then its possible its been taken down for license reasoning.Your local libruary should have it , that's where I got mine from , if niot it's well-priced on amazon :)
Place the cylinder on a flat surface. Read the volume contained in a graduated cylinder or volumetric flask, by comparing the bottom of the meniscus (the curved surface of the liquid),at eye level, to the nearest graduation or ring.
Enchanter volumes 12-19 have not been scanlated or published in English.
You can read it online at MangaReader.com. I'm not sure which chapters are included in volumes 21 to 23, but the entire manga is available on MangaReader.