to check for leaks or in the case of the cooling system preasure cap to raise the boiling point of the coolant
If the cap is not holding pressure or if it is damaged, the engine will overheat. The automotive cooling system must be pressurised, WHY?? its because when you pressurise the fluid, the boiling point will increase.
A plastic radiator will crack under extreme over heat conditions for example a defective thermostat or bad cylinder head gasket will cause a cooling system to over pressurise and rupture.
to increase the waters boiling point
Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.
The cooling system.
An average life of a system cooling device is around 10 to 15 years. This is with cont use of the system cooling device, if you do not use the cooling system then you can prolong your cooling system for a couple more years.
If there is no cooling system, the engin will overheat.
describe a cooling system with a diagram
Need to know more about the cooling system to answer this question.
what is the purpose of pressurizing a cars cooling system
COOLING SYSTEM OF WHAT ??????????????????????? Most auto parts stores sell cooling flushing kits. Get one follow the directions and it should take the air out of the system. You must remember that your heater is part of the cooling system as well as the cooling for your transmission.
Back flushing on a cooling system is when you get all of the trapped air out of your cars cooling system. This will make your vehicle run better after you do it.