Higher frequencies
the core can concentrate the magnetic lines of force
it takes time to magnetize and demagnetize iron
at about 10,000 hz we use powdered iron in some sort of glue (ferrite)
at somewhere around 1Mhz any magnetic material will no longer concentrate those magnetic flux lines
it will only get hot
so the core must be non magnetic (air is free)
open air conductors radiate heat all three ways:
conduction convection radiation
yes we can place auto transformer in place of original transformer
Ideal transformer is useful in understanding the practical transformer..i does't have losses...
It is the current transformer core meant for metering.
If the bed lamps use a low voltage bulb then the type of transformer will be a step down transformer.
If these are the exact voltages that you need you will need an auto transformer to obtain these voltages. If these voltages are nominal voltages and are of a three phase four wire configuration, the 220 voltage can be obtained from the three phase legs to the neutral (ground) connection. The equation to use is 400/1.73 = 231 volts.
Frgi transformer
yes we can place auto transformer in place of original transformer
Ideal transformer is useful in understanding the practical transformer..i does't have losses...
why should we use pulse transformer rather than ordinary transformer
we cannot use transformer because transformer cannot change frequency . . .
It is used in where the transformer are connected in star delta.
500w iron core transformer .that kind of size
As long as the transformer is capable of 12 Volts DC output, you can use any transformer with HO scale equipment.
It is the current transformer core meant for metering.
If the bed lamps use a low voltage bulb then the type of transformer will be a step down transformer.
When transformer is used in step up mode then we can use transformer as amplifire
When transformer is used in step up mode then we can use transformer as amplifire