Because they are electronic and when you turn the key on it energise them and the computer witch controls them. This is normal.
most likely a fuse is blown
Put the key in and move the steering wheel until the key can turn
move the steering wheel while attempting to turn ignition key
That is were all your gauges and lights that come on when you turn the key on is. You look at it all the time to see how fast you are going.
Dead battery or a broken battery wire
Your ignition also locks your steering and at times you need to move the steering wheel a little and at the same turn your ignition key. Then you should be able to turn the key and start the engine. Hal
this was my question i found the problem a rat had chewed my wires behind the pcm i also found out if your lights or gauges don't work you are not getting power to pcm
Having a short in the turn signal wiring can cause gauges to fluctuate. If the battery gauge is fluctuating corrosion on the cables can be a possible cause.
the gauges move in the first place bacause of air pressure/temp so when u shut off your car the pressure is released because the gauges would break more frequently otherwise.
Most likely your steering lock is engaged. If you try to move the wheel right to left (or vice versa) while trying to turn the key it will work and turn. Sincerely, Bora
just turn the key til the point it goes(gently).when it stops,move the steering wheel while turning the key.
just turn the key til the point it goes(gently).when it stops,move the steering wheel while turning the key.