On the front side of the throttle body on the left side is a air valve with 2 tork screws. Remove it and clean the carbon out with gumout spray or replace it. That is the fast idle valve. that is why when you start your engine it revs and idles down.
Pro: you are able to change gear when your engine revs are different from your transmission revs. Con: when torque is high or the difference in revs (see above) is too big, it will slip.
Pro: you are able to change gear when your engine revs are different from your transmission revs. Con: when torque is high or the difference in revs (see above) is too big, it will slip.
turbo
Replace the TPS (Throttle Position Sensor).
try the idel air control valve
Vacuum leak?
Gear changes are determined after how fast the engine is turning. For each gear there are set limits for which engine revs that are allowed. if the revs go high, the transmission changes up a gear, if the gears go low it drops down a gear.
When i had this prblem it was my mass air flow sensor check the wiring and clean the sensor its an expensive part if its bad put simple to replace
you are stepping on the gas peddle too hard
it depends on the engine. generally it boosts the performance at high revs
Year? Replace ECTS and clean the throttle body
it basically lets the bike work at higher revs, for example on mine it gives it unlimited revs, so it wont stop at about 6000rpm like a normal bike but just keep going, it can be bad because if the revs get too high the engine may explode