0
I would assume that the wires are hooked up backwards
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why would the gauge read empty when the gas tank is half full?
Most Likly a fuel sender problem
Why gas gauge read empty 1967 Pontiac gto when full?
Bad connection, blown fuse, or the float in the tank is stuck.
Would it be correct to write My gas gauge read E?
It would be better to write: My gas gauge reads empty. Note that 'gauge' is singular, so it needs the singular verb, reads. If you had several cars all with gas gauges that read empty, then the verb would be read.
Beretta gas gauge stuck?
Where is it stuck? on full or empty? if on full you got a bad ground, if empty you got a bad float.
Your gas gauge is jumping from full to empty what to do?
fuel sensor in the gas tank is bad or the wires to it are loose or broken.
What causes Gas gauge on a 1997 Monte Carlo to always read empty?
no power at the sending unit.
Why does a Chevy truck gas gauge go from full to empty when the key is turned on?
bad sending unit
Why would the gas gauge in a 99 Chevy Malibu LS say full when empty?
The fuel sensor in the gas tank is bad.
87 Chevy silverado gas gauge reads a quarter at full on both tanks falls as gas is used to empty checked ground and connections unpluged the sending wire at tank and gauge goes to full thank you?
my 86 did the same never would read more than 1/4 tank after lots of checking things i replaced the gauge and it worked perfect..
My fuel gauge was three quarters full then twenty miles later showed empty. I filled it with eighteen gallons and it holds thirty one. Why does your fuel gauge show empty all the time?
probably no gas, if there is gas then your gauge in the tank is broken or frozen
Your gas gauge in your 1990 Dodge Dynasty has a full tank of gas but the gas gauge still says it's on empty how do you fix this problem?
Its probably the float in the gas tank that tells how much fuel is left in the tank... its sticking.
Why does the gas gauge not work in 1998 Chevy Suburban?
Your gauge could be bad but sometimes the floats in the gas tank get holes in them and fill with gas. this causes the float to stay at the bottom and your gauge to read empty. U might also check the wiring from the sender at the fuel tank to the gas gauge itself.
