check the fluid level as discussed in owners manual
use 1 bottle grease lightening trans addictive--at napa etc
The Camry in 1990 doesnt have a shift solenoid. It was controled by a hydraulic shift governor inside the transmission. So the trans. has to come out and be opened up.
Check transmission fluid level.
1994 Toyota Camry xle v6 brake mechanism causing tranny to lock where is it located?
Most likely you did not set correctly the tension in cables connecting the shift stick with the transmission.
If you assume that transmission is in a good condition, the only thing which can do to that is neutral safety switch.
In a 2005 Toyota Camry, the ECT (Electronically Controlled Transmission) PWR button is located on the center console, typically near the gear shift lever. It may be labeled as "ECT PWR" or simply "PWR." Pressing this button activates a performance mode that enhances acceleration by adjusting the transmission's shift points.
Couple of possibilities: The external shift linkage is out of adjustment. the "pawl" inside the transmission is bent or broken.
THE SHIFT SOLENOID IS LOCATED ON THE OUTSIDE OF THE TRANSMISSION, BEHIND THE SELECTOR SWITCH. IT IS HELD IN PLACE BY 2 10MM BOLTS Angelo !!! wrong answer!!!! shift solenoids are located on top and the back of valve body.
Check the transmission fluid level, also make sure that the safety switch did not go bad.
The tranny is probably ****** so it wants to shift while its on P or park so I suggest get a new transmission
There is a little button on the transmission shift stick, from the driver's side. Just press it, and you will see light in your dash board... And you will get what you want.
There are a couple of reasons why a 1993 Mercury Villager is hard to shift. One reason could be a gear shift cable. Another reason could be low transmission fluid.