sounds like a loose belt, glaze belt
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
To reset the oil change required light: turn key on, engine off; press gas pedal to the floor three times; cycle key.
unbolt master cylinder from boosterdisconnect pushrod at brake pedal arm under dashdisconnect vacuum hose from boosterunbolt booster from firewallreverse order to install new booster
The brake pedal has a hinge or pivot pin, give it a shot of lubricant,should stop squeaking.
The sustain pedal on the far right is used to sustain the notes played on a piano. This is true for both vertical and grand pianos.
One sign of a brake rotor going bad on a Jeep Grand Cherokee is a vibrating steering wheel. Another sign is that you feel your brake pedal pushing back.
Accelerator pedal, cruise servo, and transmission kickdown cable.
if you look under the dash at your brake pedal if automatic trans,and if its standard look at the clutch pedal and look for the switch,this is not a hard job to do but it will take patience.
A short in the brake light circuit.
There should be a contact switch just in front of the brake pedal up under the dash panel.
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
Turn the ignition on, engine off. Press the gas pedal to the floor three times in 10 seconds.
If it cuts out at idle or when your foot is off the gas pedal, its the Idle Air Control sensor.
check the spark plug ... do not start it by bushing the fuel pedal . just start it by doing nothing els ...
If your 2003 Grand Am accelerates without pressing the gas pedal, the throttle plate may be stuck.
Defective or mal-adjusted stop light switch? Usually located at the upper end of the brake pedal under dash area
Could be a vacuum leak Could be a defective power brake booster Could be a bad check valve on booster