answersLogoWhite

0

Why does brake pedal go to floor sometimes 96 olds aurora?

Updated: 8/16/2019
User Avatar

TTbyrd49

Lvl 1
15y ago

Best Answer

sounds like overheating of brake line, either from hot pavement, or cat converter. causes brake fluid to boil and loss of pedal.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does brake pedal go to floor sometimes 96 olds aurora?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does my 1978 ford f250 power brake pedal go to the floor sometimes. Fluid is up.?

Sounds like a master cylinder.


What causes brake pedal to go half way to the floor on a 1999 ford explorer?

Something is impairing the brake pedal to go to the floor. Only a mechanic can tell you what is happening.


What are the symptoms of a defective master cylinder?

usually they will leak out the back by the booster, your brake pedal will slowly go to the floor at stops or the brake pedal will go right to the floor when pushed.


Can worn brake pads make your brake pedal to go to the floor?

no you have a brake fluid leak somewere


1997f-350 brake pedal goes to floor?

ouch,are brakes adjusted correctly/ sit in vehical and pump pedal to get a full pedal,then hold pedal to see if it bleeds off and goes to floor,if it stays, replace shoes and pads if it goes to floor, there is a fluid leak somewhere is there brake fluid in the resevoir/ are there any brake fluid leaks ,check backside of wheels there is a brake fluid pump, on the chassis rail about level with the front of the front door on the left side.if this pump is bad your pedal will go to the floor


Why does my 91 crown vic Brake pedal go to floor sometimes and works good other times?

The master cyl. could be by-passing. have it checked.


Why does your 93 jaguar xjs brake pedal sometimes goes straight to the floor?

it's very possible that its the anti lock brake booster. Its that round black ball with yellow lettering on the right hand side of your engine compartment. When that starts failing your brake pedal can go down to the floor or even kick back at you sometimes. The part is about $200.00, but you need a specialist to replace it because its under high presure.


How do you know if master cylinder is bad?

While parked and applying steady pressure on the brake pedal with your foot, eventually the pedal will slowly (sometimes quickly) drop to the floor without losing a drop of brake fluid. This is condition is called master cylinder "blow by".


Where is the brake light relay in 1999 Oldsmobile Aurora?

Fuse and/or switch Switch located at upper end of brake pedal under dash


Why does the parking brake pedal go to the floor on a 97 suburban?

probably have broken parking brake cable.


Can the brake booster cause your brake pedal to go to the floor?

No, a busted brake booster will not cause the brake pedal to go to the floor. It will however cause the brake pedal to be extremely hard to push. A defective master cylinder will cause what you describe. Replace the master cylinder and bleed the brakes. It can because it happened to me. The booster lost vaccum and the pedal went to the floor. Sorry, you are wrong. The only reason the pedal went to the floor was because the master cylinder failed. The brake booster only boosts the pressure on the master cylinder and allows you to not have to push so hard on the brake pedal. Cars of yesteryear did not even have a brake booster and they stopped just fine albeit you had to push the pedal allot harder than with power brakes. A failing brake booster will not cause your pedal to go to the floor although it might cause it to go lower than normal before the brakes apply. As long as the master cylinder is good you will still have brakes, but you will have to really push hard and might even have to pump them up in order for them to stop the car.


Why do the brake lights on a 1992 Mustang only come on when the brake pedal is pushed all the way to the floor?

The brake light switch is out of alligment. Check on the brake pedal arm and readjust the switch.