The engine runs a lot hotter than a four stroke engine, you should only use oil that is made specifically for a two stroke motor other wise you run the risk of catastrophic failure.
assuming that you have already done that then the other reason is that in the process of firing and compressing the pistons, there is a stroke that can be referred to as a dirty stroke ( that is why a two stroke has such a gassy smelling exhaust) this stroke is one that lines the walls of the cylinder with a thin film of lubricant (oil / gas mix) to make way for the next stroke, the combustion stroke. Now after the engine has warmed up enough the gas portion of lubricant vaporizes and is ignited and helps with compression of the other piston(s). so that process burns the oil and in turn will make the oil per to say turn black.
Two stroke engines should be taken apart and cleaned pretty regularly and proper jets should always be adjusted or replaced under hard use, they do wear out like water running down a river bed.
what should i do if my engine oil go,s black in my bmw 520d
ngk number is br9hs gapped at .030 and must use quicksilver 2stroke oil mixed at a 50:1 ratio
In the engine, usually through an oil filler cap.
It is burned by the engine combustion process or it is leaking out of the engine.
yes you can synthetic oil can go in any engine
The 2004 Toyota V-6 engine oil capacity is 4.5 quarts. 4.0 quarts will go into the engine and one half quart will go into the oil filter.
The 2001 Toyota Corolla engine oil capacity is 4.5 quarts of motor oil. For quarts of oil will go into the engine and one half quart of oil will be in the oil filter.
even if the oil filter is clogged the oil will still go to the engine via the bypass valve but it is not filtered but if no oil goes to the engine it will soon seize up and be destroyed
If you have the correct amount of oil in the engine, unhook the negative (black) battery wire for about 15 minutes. Then hook it back up. The light should go off, especially if you hooked up the oil sender wires BEFORE putting the oil in.
in the top of the engine there is a cap with an oil can sign on it . Fill the oil in there. Be care not to over fill as it can cause the engine to cease!
if it is a 2stroke it can go like 90+ depending on the condition of the bike. if its a 4stroke it can go about 80 on the road
The speed of a go-kart powered by a 2hp two-stroke engine typically ranges from 15 to 25 mph, depending on factors such as the weight of the driver, the design of the go-kart, and the terrain. Lighter go-karts with efficient aerodynamics can achieve higher speeds within this range. Additionally, modifications and gearing can also influence the top speed.