Want this question answered?
Chalk particles can be collected by using a filtration process. A filter paper or a fine sieve can be used to separate the dissolved chalk particles from the water. The water can then be evaporated to obtain the solid chalk residue.
Firstly mix the water well to make sure all of the sugar has dissolved. Then, depending on the weight of the chalk (whether it is in chunks or powder form) it will either sink to the bottom of the mixture of float on top. If the chalk is floating on top, you can simply scoop it out. Otherwise, pour the mixture through some filter paper to separate the chalk from the sugar water. Now, once the chalk is separated, you can boil the water to evaporate it, leaving just the sugar behind.
Filtration would separate the water, leaving the chalk particles behind.
Filtration would separate the water, leaving the chalk particles behind.
we can filter the mixture of table salt and chalk dust by using the process called filtration because when you mix the table salt with water and chalk dust together, it becomes an insoluble mixture called suspension
Pass the mixture through filter paper. The salt water will pass through leaving the chalk behind in the filter paper.
You can add water to this mixture, which will dissolve the salt but not the chalk. Decant the water, then boil it away, and you will be left with salt.Salt is much more soluble in water than chalk is.
first, put the mixture in water . salt will dissolve and then allow chalk powder to settle down. Then try decantation.
Because chalk(CaCO3) is insoluble in water and more over if you pass the mixture through a filter paper the chalk is left behind on the paper while the water seeps through it .
Use a magnet to remove the iron filings from the mixture, then mix the remaining components with water. The copper sulfate will dissolve but the CaCO3 (chalk powder) will not. Filter the mixture to remove the chalk, then boil the water to recover the copper sulfate.
Chalk particles can be collected by using a filtration process. A filter paper or a fine sieve can be used to separate the dissolved chalk particles from the water. The water can then be evaporated to obtain the solid chalk residue.
Firstly mix the water well to make sure all of the sugar has dissolved. Then, depending on the weight of the chalk (whether it is in chunks or powder form) it will either sink to the bottom of the mixture of float on top. If the chalk is floating on top, you can simply scoop it out. Otherwise, pour the mixture through some filter paper to separate the chalk from the sugar water. Now, once the chalk is separated, you can boil the water to evaporate it, leaving just the sugar behind.
Filtration would separate the water, leaving the chalk particles behind.
Filtration would separate the water, leaving the chalk particles behind.
Due to the chemical composition of Chalk, you can separate it from water either by filtration of evaporation.
Stir stones, chalk and water until the chalk is in suspension. Pour off the chalky water (repeat as required), leaving the heavier stones behind. Filter the chalky water to let clear water pass through, so leaving the chalk in the filter paper.
First remove iron filings with a magnet. That leaves sand, salt and chalk dust. Add water which dissolves the salt, and filter leaving the sand and chalk dust on the filter paper. Put that back in water and add acid to dissolve the chalk dust (CaCO3) leaving the sand as a solid. Filter to obtain the sand. The chalk dust will now be in the acid as CO2 and H2O and the Ca salt of the acid.