Fuses That "Keep Blowing" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specificcause/defect which is causing your problem.
However, the following generic answer applies to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors. And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
do you have 2000 mazda 626 dash board?
It does not have one.
Its almost definitely in the fuse panel
The fuse box diagram for the 1995 Mazda 626 is located under the lid of the fuse box. You can also find this diagram in most Chilton's repair manuals for that vehicle.
The CPU for a dome light on a Mazda 626, and most other Mazda vehicles, is located near the main fuse box. This is found under the hood.
Because its not really a Mazda 626... Its a Delorian... ..
this is the 30 amp egi fuse in your fuse box in your engine comp.
How do you change the liscence plate light fuse
Dealer or salvage yard.
check the fuse to make sure it has not blown out
check the owners manual..should be doors and such..
because you car is stupid