answersLogoWhite

0


Best Answer

Could be,Faulty check valve in the fuel pump,

Faulty or dirty needle and seat in carb,

Faulty or out of adjustment fuel float in carb,


User Avatar

Wiki User

6y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does my 1973 350 not hold fuel pressure after shut down?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What holds fuel pressure on Jeep Cherokee?

Correct me if I am wrong but a fuel pump does not hold fuel pressure it maintains the fuel pressure needed for the vehicle to run. What holds the fuel pressure is the fuel injectors and believe it or not the fuel pressure not only regulates the fuel pressure but also holds it. If the regulator is bad your vehicle will not hold the pressure needed to run the fuel pulse dampener also plays a small roll in this question too


Why does my 350 not hold fuel pressure after shut down?

Could be,Faulty check valve in the fuel pump,Faulty or dirty needle and seat in carb,Faulty or out of adjustment fuel float in carb,


When you start your car in the morning it wont stay running you have to hold the gas down What is wrong?

If your car has the check engine on it could be your fuel pressure regulator located on your fuel rail..


Does the fuel pump hold pressure or sending unit?

The fuel pump has a check valve that holds the fuel pressure. The sending unit monitors the fuel level in the fuel tank.


Your 1991 Buick lesabre hard to start after sitting all night must hold accelerator down while cranking then runs fine all day you checked the valve after sitting all night no fuel till cranking?

check your fuel pressure at the rail. the regulator may be going bad. * turn key to on but not running. check for pressure. fuel pressure should hold for about 1-2 min at the rail before it bleads down. if you have an inital blast of pressure and then it is gone in 10-20 seconds change the regulator.


Your Ford 250 Van is running lean how do correct that?

check your fuel pressure. With key on engine off it should be 35 - 45 lbs. It should be 5 or 10 lbs higher with engine running. It should hold pressure for 15 min. - within 5 lbs after key is turned off. If pressure is low, or if pressure bleeds down quickly something is leaking. If fuel lines are ok. Either check valve on fuel pump isn't holding, or one of the injectors is leaking, or the fuel pressure regulator is returning the fuel to the tank. cycle the key on and off a few times to build up pressure and seal off both supply and return fuel lines. if pressure still bleeds down one or more fuel injectors is leaking. if pressure holds, release the return fuel line if pressure bleeds down its the fuel pressure regulator that's leaking. if pressure holds release the supply line if pressure bleeds down now its the check valve on the fuel pump.


How much fuel pressure does a 1995 Chevy Blazer hold?

The fuel pressure specs. are 9 to 13 LBS./PSI no more and no less.


205 gti starts and then cuts out?

Fuel pressure problem, faulty fuel pump or filter. Check fuel delivery by releasing fuel hose where it enters the engine. Hold the end of the hose in a bottle and have an assistant start the engine. You should get a nice stream of gasoline pouring down the hose. If not, the fuel pressure is too low, check fuel filter and pump.


What would cause the fuel system on your 3.1 cavalier not to hold pressure when not running?

The fuel pressure regulator is bad, one or more fuel injectors is leaking or the check valve in the fuel pump is faulty.


What should the fuel pressure be on a 1991 suburban and with the key on should it build pressure and then drop to zero.?

Fuel pressure should read no less then 9 LBS. and no more then 13 LBS. And yes it should hold the pressure with key on, engine off.


91 Audi 80 5cyl fuel injected wont start or hold idle has fuel pressure to oval injection block but no fuel coming out of injector lines it does have pressure at line to head with blue elec connecton?

It may be that the mechanical fuel distributor is broken. Try taping on it.


How do you replace the fuel pump on a 1988 Ford F-150?

there are 2 fuel pumps if you have 1 tank or 3 if you have dual tanks. A low pressure pump in tanks and high pressure on along frame rails on drivers side behind fuel filter. it is kind of easy to change the high pressure one. . if in fuel tank replaced you will have to remove tanks or remove the bed with the help of 4 friends to help pickup bed after you remove the 6 bolts that hold down bed and have to remove tail light and drop down tail lights through bed. Good luck