Is the binding cut on the bias (it should be) and have you used the correct thread. Sometimes the thread can shrink differently from the material being sewn.
Use a warm rag and pull apart the fold and wipe them then put some hydrogen peroxide on it and some neosporin. Make sure to keep the folds clean to prevent further irritation.
There are two yellow pull levers at the back of the trunk of the car, located on the back of the seats. Just pull them to disengage the seats and fold.
There are two pull down ropes in the trunk near rear speakers. One for each side, pull down to unlach seat and fold down.
there are pull straps on both sides of the seat that you pull and that section will pull down.
If it's the rear seat then there should be two buttons on the top of the bench (one on each side). Pull up and then fold it down. If it's the front seats there is a lever on the side facing the door and you pull up and fold down.
Pull out the two crossbars at the end, fold the cot along the center hinges, fold in the legs, then the main rails fold into three sections.
Lift the bottom of seat(bum part) and fold forward, pull red strap behind seat and it will fold into the floor
Pull.
To add fringe to the edge of a finished crochet project, cut as much yarn as you want at double the length, fold yarn in half lengthwise, pull the looped end through the stitch where you want to attach the fringe, and pull the loose ends through the loop and pull tight.
There should be a little lever behind the seats. Pull up on this and then the seats will fold down for you.
You should be able to do that. There are two nobs one per each side you have to pull out, if you want to fold the seat. You can fold one side only if you want to.
On the back seats, there should be a pull cord located near the seat belt latches. If it is not there, they are probably shoved behind the seat cushion, in which case you will have to dig then out. That pull cord enables the whole seat cushion to fold forward allowing the seat back to fold completely down.