Each appliance has its own amperage. This can be shown by looking at the label of each appliance. A circuit is protected by a breaker which has a trip limit. By continually adding more amperage from different appliances, the circuit becomes overloaded. When the circuits limit is reached because of the additive effect of more appliances to the circuit the breaker will trip. This disconnects the appliance loads from the distribution panel supply and prevents over loading of the conductors of that circuit. Without removing some of the load amperage, the breaker will keep tripping when reset.
DC = direct current.
Yes. Current consists of electrons flowing in a circuit.
If the circuit is closed the electric current will be closed as well.
That is called electrical current.
In a circuit, the purpose of a switch is to control the current flow to the load by opening the circuit (off) or closing the circuit (on). When the circuit is open, the is no complete loop through which the current can flow. When the switch closes the circuit, it restores the loop, and thus allows the current to flow.
A closed path through which a current can flow is called a circuit. Electric Circuit:)
Because there is many path for flowing current through circuit.
DC = direct current.
Current flows through a complete circuit.
Yes In parallel circuit , current entering into the circuit will be divided intodifferent paths ( resistances) . Amount of current flow depends upon the magnitude of resistance applied in the circuit. Total current after passing through the circuit will be the sum of all current through each resistance.
The current measured at any point in a simple circuit will be the same because current is the measure of electron flow through a circuit. The current flowing through any branch of any circuit (or an entire simple circuit) will always be the same at any point.
complex circuit
Closed circuit
No. But the current through it does.
A circuit breaker is a device used to open a circuit if too much current flows through it.
If two circuit elements (e.g., two resistors) are in series (a series circuit), the current has to pass first through one, then through the other. If they are in parallel, the current has a choice, through which of the elements it passes.
In a series circuit, current has to pass through each part of the circuit. In a parallel circuit, the current has several alternative paths.