answersLogoWhite

0

Why does radio reset when remove ignition key?

Updated: 8/17/2019
User Avatar

Turnip2

Lvl 1
13y ago

Best Answer

because you have the constant power and the ignition power crossed

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does radio reset when remove ignition key?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reset central iocking 2001 mondeo?

Turn ignition on and off quickly 4 times, remove key from ignition, you will then hear tone, point ignition key towards interior light and operate the central locking. This will reset it.


How do you remove the key from the lock ignition?

1996 rodeo- how to remove key from lock ignition?


How do you reset the ecu in the 97-00 cr-v because i dont find any ecu fuse to remove in fuse box inside the car and in engine hood?

remove the radio/back-up fuse(7.5amp) located in the fuse box in the engine compartment passenger side, for 5 minutes. be sure that the ignition key off..better..remove the key from the ignition...or you could fry your ECU.


How to reset a mini Cooper key?

To reset a Mini Cooper key, get in the car and close all the doors. Put the key in the ignition, turn it to the first position then back again to off and remove the key. This must be accomplished within 5 seconds.


How do you reset your ignition key on a Mercedes clk 230?

leave the key in the ignition over night key should reprogram


How do you remove and install a ignition key from a Saturn?

Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.


How do I reset the imobiliser dash light on Nissan Micra k12 model?

ignition on for 15 mins remove key reinsert ignition on light should go out hope this helps


How do you remove ignition key stuck in Chevy colbalt?

how to remove key stuck in ignition switch in Chevy colbalt


Can't turn ignition to remove how else can you remove the ignition to replace?

You have to have the key to that ignition to remove it. You can get a locksmith maybe. The dealership can make you a key from your vin# definitely good luck.


How do you reset a Mercedes ML key fob?

1 Insert the key into the ignition. 2 Press and hold the "LOCK" button on the key fob. 3 Remove the key from the ignition. Keep the "LOCK" button held down while removing it. 4 Press and release the "UNLOCK" button five times. 5 Release the "LOCK" button. The fob is reset.


How do you stop the key in ignition chime when the key isn't in the ignition?

Find and remove the chime.


How do you remove a ignition key tumbler in a 1977 Chevy pickup?

Remove the retaining ring from the top of your 1977 Chevrolet pickup truck ignition key tumbler. Slide the ignition key tumbler out. Remove the wiring harness from the end of the key tumbler.