Lock cylinder must match the key for security system to work
Yes, the blinking securtity light will blink when the car is off.
You want the red light to blink, as the basic Toyota security alarm is contact based, meaning it will sound the horn when a door is forced open. The blinking red light shows that the system is armed and will activate when the doors are secure and locked.
If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.
If the check engine light is blinking , an engine cylinder misfire has been detected
94.9 then you will see the security light on wait about 30 sec's it will start to blink then its on.
Sounds like you blew a cylinder in the engine.
The security light comes on after you changed the keys in the ignition from the off position to the on position as a confirmation that the electrical components in the dash board are working. It is nothing to be concerned about.
Usually in the ign lock cylinder if you have the VATs type key with the resistor in the key. The wires attached to the key lock cylinder often break. If you have the "pass key" type without the little resistor chip then it is different. But it also usually involves removing the key lock cylinder.
Yes if it is working correctly.
If your check engine light is blinking , that means an engine cylinder misfire has been detected - your vehicle would need to be scanned for any trouble code(s) to determine which cylinder or cylinders are misfiring
It's telling you that you have a problem. Get a code scanner and find out what the problem is. that's a misfire .i had tht problem and i changed the spk plug cable
why does my airbag light blink off and on on my 92 mercury gran marquis ls