answersLogoWhite

0


Best Answer

You might have a bad battery, a poor connection between the battery and alternator, or a bad ground from the battery.

User Avatar

Wiki User

โˆ™ 2017-01-08 02:25:03
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Why does the battery light stay on after replacing the alternator 2009 Chevy Malibu?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Steps on how to replace the alternator of 2002 3.1 Chevy Malibu?

where is the location of tensioner of 2002 3.1 L Chevy Malibu to adjust if replacing the alternator?


Why does battery light on in Chevy Malibu?

Alternator is not charging. Have it tested and/or replaced.


Where is the location of tentioner of 2002 3.1 L Chevy Malibu?

where is the tensioner of 2002 3.1 l Chevy Malibu to adjust so that i can remove the belt when replacing the alternator?


1987 Chevy blazer wont turn over after replacing starter?

did you check your battery and alternator?


How do you change the alternator on a 1999 Chevy Malibu?

Remove the belt from your 1999 Chevy Malibu alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


Where is the voltage regulator on a 98 Chevy Malibu?

Its in the alternator!


How do you get the battery light to turn off on a 1998 Chevy Malibu?

When this light stays on, it is telling you the system is not charging. Possible bad alternator, battery, or loose or disconnected wire.


What is the car that's replacing the Chevrolet Cobalt?

The Chevy Cruze and the Chevy Malibu


How do you know when you alternator go out 2001 Chevy Malibu?

Check the output at the battery posts. With a multimeter it should be putting out between 13.5-15 volts.


Why 2000 Chevy Malibu runs for a bit then shuts off and when trying to start again battery dies?

more than likely it is your alternator, have it tested.


How do you replace the alternator on a 1997 Chevy Malibu?

disconnect negative battery terminal, remove the drive belt. then disconnect the output wire and electrical connector on alternator. remove mounting bolts and remove alternator. good-day !


Which cylinder is 1 on a Chevy Malibu 3.1?

the one closest to the alternator

People also asked