0
so it wont over heat (its coolant and its not supposed to be oil... coolant is milky white) that is all i know from a shop
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you fill my 97 jeep rear axle with oil?
Remove the plug in the center of the cover plate. Squirt oil in until level with bottom of hole.Remove the plug in the center of the cover plate. Squirt oil in until level with bottom of hole.
How does a center lathe work?
It doesn't.
Use of center lathe for Friction welding?
Centre lathe can use for friction welding.
What is the size of a lathe that measures 6in from the center of the spindle to the main bed?
A lathe that measures 6 inches from the center of the spindle to the closest part of the bed is considered a lathe with a 12 inch swing.
What does changing the gears on the center lathe do?
Changing the gears on a lathe enables it to cut certain pitches of threads.
What is function Spindles in the lathe?
function spindles in the lathe There is a long time to find a center cutting machine parts and maintenance.
Where is the rotor point at top dead center?
Iti Lathe
What is the use of the tail stock sleeve in centre lathe machine?
Tails tock sleeves are used on CNC lathes. It is the equivalent to a tail stock quill on a center lathe but in this case it uses hydraulic pressure to move it in and out of the tail stock. The function of both tail stock sleeve or quill is to clamp the workpiece by means of a center that is inserted into the sleeve or quill. On a center lathe it is used for drilling also but not on a CNC lathe.
How do you use the center lathe safely?
by not being a douche? its one of easiest to use!
What do you have to do to a hydraulic lifter prior to installation?
pump it full of motor oil with an old squirt oil can
What is the difference between center lathe and capston?
The centre lathe has only one coaxial tool, whereas the capstan has a rotating multi tool station with indexer and clutch.
What are the accessories used for on the center lathe?
Accessories used on a center lathe are:3 and 4 Jaw chuck - Clamping the workpieceChuck spanner - For tightening the workpiece in the chuckSteady - Stabilizing a long workpieceTraveling steady - Stabilizing a workpiece close to the cutting areaCenter, dead center, pipe or rolling center - Centralizes and stabilizes the end of the workpiece from the tail stockCutting tools - Used for cutting or machining the workpieceWrench set (Supplied with the machine) - For setting the gears at the rear of the headstock for specialized operations and machine maintenanceManual oil pump - For lubrication of the machine
