Because it is a toy gun and cheap
you have a bad clip.
there are two tourqu screws one on each side undo thes and slide out light then release the clip on the bulb from the back side and slide out the bulb
When you are making a power point presentation, be sure that all of the slides relate to the topic. If you do not have pictures to use on the slides, you can include clip art from Microsoft Word. You can go back to each slide and add things to it after you are finished with your power point presentation.
just pry out the metal retaining clips from each end. to reinstall, partially slide each clip into the groove then place strut on studs and slide clips on the rest of the way.
CLIP THE LEADS BACK ON TO EACH METAL TAB
there are clips on each side of the headlight housing under the hood. Pull each clip to release the housing. It will slide out towards you. Then you can pull the bulb out.
If it is the same as the '85 or '86 models, you will see 1 bolt on each side of the lower part of the seat, they could be the adjuster bolts for the seat to slide forward or back, towards the back of the seat, need an Allen key for this, remove them, the seat will slide either forward or back, ( cannot remember ) Once you slide the seat, it will release from the clip underneath the seat. If you do have no success this way, with the 2 rear bolts removed, peel up the front part of the seat, on the side, you will see on each side 1 bolt, us a wretch and remove them. Should do the job.
No, PowerPoint does not assume so -- each slide has a layout that may include a placeholder for clip art. Alternatively you can use the Clip Art button on the Insert tab of the Ribbon. More info can be found on Indezine in the related link.
An airsoft repeater is an airsoft gun that you have to cock to get each round in the chamber.
All of the new beetles have a slide inside the engine compartment on each side by the fender,push it down and then you have to slide the light assembly out it is quite long so don't think you are doing anything wrong,then you take the lens loose and change the bulb,do not touch the bulb with your hands use a cloth or paper towel.If you touch it it will cause it to blow faster.when you get the bulb replaced put the lens back and then you have to get each side of the part you slid out back in the channel to push it back in position.There is a slide on each side of the part and on each side of the hole you are putting it back into.When back in position then push the slide back down inside the engine compartment.
you need to unscrew the 4 hex head screws in each corner, then use a radio removal key (or 4 pieces of wire about 2.5mm thick) insert into each hole. this unclips a clip in each hole and lets the radio slide out
Remove end caps with small flat screwdriver. They clip on top and bottom at each side of radio. Remove both torx screws. Slide radio out and unplug.