I get 10..
The heater core is mounted to the passenger side firewall on the 1988 Buick Electra 307. The blower motor needs to be removed to access the heater core.
on mine it is right behind the glove box
it is behind the glove box
The starter is located under the engine, right alongside the crank case. As you look to the front of the car, it's on the left side of the crank case.
to the left of your strearing wheel under panel with the light switch
I have an 89 Buick electra park avenue, and I have averaged 23.3 over the last 2 weeks, using the air conditioning, and with a fair amount of in-town driving, but probably 80% highway driving.
The 2.8 engine doesn't use a cam sensor.
Because its a 1988 Buick LeSabre
choke idle adjustment on 1988 Buick Riviera
Buick Reatta was created in 1988.
William Buick was born in 1988.
Get a test light and find out where the power is not coming through. Check the fuse, relay and resistor pack located on the evaporator case.
Procedure to change 1988 Buick regal head gasket
it says 16.8 gal. on manual...
Relay is on heater/AC ductwork under hood on passenger side of engine compartment
The 1988 Buick Skylark 2.3 liter engine serpentine belt tensioner pulley is held in place with a single retaining bolt. The retaining bolt will be in the center of the pulley. Remove the retaining bolt.
Aliens Ate My Buick was created in 1988-04.
There's a round cover on the bottom of the engine oil pan, you need a special tool to remove it, it's inside that hole.
Check to see that the heat control is working, and water is flowing through the heater core. Make sure that the engine thermostat is not stuck open, and the engine coolant is full.
Note that a 2.8L engine is a V6 and has two valve covers. Did you try looking at the other valve cover? == == == == IT'S ON THE VALVE COVER WHERE THEY ALWAYS ARE. I have this car and it is not there!
With the torque converter about 11 quarts. without about 7 quarts.
What is the firing order on a 1988 Buick Century.