Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, whether direct current [DC], or alternating current [AC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or repeatedly "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do; that is to protect the conductors and components of the circuit which it serves.
The proper "fix" for this issue is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.
Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and the probability of an electrical system fire.
The alarm is built into the body computer and can not be removed. If you are blowing fuses, you have an short to ground or a current overload.
Short in the wiring or the lamp holder for the tail light is corroded.
It is very common for the starter to be the cause of that fuse blowing.
The starter has failed.
Where is the fuse box for a dodge sebring
A failed starter is a likely cause.
A fuse blows when the current in the circuit passes what the fuse is rated at. If you are blowing the ECM/starter fuse, the starter is probably bad.
There is not one.
in the fuse panel under the dash. its number 15
Number 8, I think its the second 20amp fuse from nearest the driver seat side.
The1999 Ford F1 50 pickup truck 5.4 liter engine alternator field fuse can be found in the fuse box. The alternator field fuse will be in the second column, second from the top.
Could be a shorted socket? Could be a bad element? Replace both--should solve problem