Want this question answered?
If the light is not coming on when you turn on the ignition, check the bulb, it may be blown.
You can turn, but do it cautionously. Other cars may also be coming.
just keep goin forward
Stop, look both ways, and then proceed if no vehicle is coming.
In most US States, you can never turn left on a red light. You can turn right on a red light if there are no signs saying you can't, but you have to wait for a green light and a clear intersection to turn left.However, in Michigan specifically, you can turn left on a solid red light if you are turning onto a one way street and have no on-coming traffic. You have to come to a complete stop before the crosswalk, and yield to traffic, but unless there is a sign to prohibit it, you CAN turn left on a red light onto a one way street.
In an unprotected turn, you have a directional arrow that is green that allows you to turn. Cars coming from other directions have red light. An unprotected turn means you proceed when it is safe to do so.
Either the bulb in the turn light is burned out or there is a short between the light and the switch. The turn signal switch is broken and needs to be replaced. I ran into this once before. For me it was a bad ground coming off the light itself. I don't know if that helps but you can give it a try
In theory you would not see them because there is no way of the light getting to you because for that to happen you would need to travel slower than the light or the light would have to be coming from the opposed direction
some motion lights have a setting on the actual light where it will stay on when the light switch is in the on position. There are also some that if you turn the light off and immediately back on, it will stay on (the ones that I have have both of these functions).
You have to repair the cause of the light coming on in the first place. You will need to have the code read, repair the cause, and then the light can be shut off with the scan tool.
It might be because of dust in the atmosphere elevated by the explosion. Particles of dust absorb and scatter visible light very well. And the sky turn to black because there is on light coming through dust clouds.
You pull your turn signal lever towards you, and you should hear a click. Make sure your truck is on. When you have done that you will see a blue light in the middle of your speedometer and RPM gauge. It is a picture of a light with beams coming off the light. That is how you know that you have turned them on.