0
What else can I help you with?
On a 2004 maxima the gas needle is behind the post how do you Fix?
how do u fix a gas needle on a 2004 nissan maxima
How do you check for bad valves?
By hooking up a vacuum gauge could help indentify bad valve. the needle of the gauge would bounce erractically during idle.
Why would a 1998 Nissan Maxima's RPM needle go down to 3 or 1 and then turn off plus also shake when reaching speeds of 40 or higher?
Why would a 1996 Nissan maxima's RPM needle go from 2 to 6 and seven, back and fort like crazy.
Is there a fuse for a dead speedometer needle and where is it located on a 1996 Maxima?
I don't belive the speedomoter has a fuse it would probly be a bad cable or a bad sensor on the transmission
What kind of speed does a speedometer show in a vehicle?
Acceleration is not represented on a speedometer, however, when you look at the speedo, if the needle is moving, you can get a rough idea of acceleration like this: If the needle is going clockwise (of generally indicating faster speeds) - you are accelerating. If the needle is going anticlockwise - you are decelerating. Speedometers measure speed. You would need an accelerometer to measure acceleration.
High acceleration temp gauge needle pointer goes down to low temp release the acceleration going back to normal temp?
Need to no more info, Year, engine size, what type of truck. It would help us answer it correctly. THANKS.
Why does temperature gauge needle move with acceleration?
during acceleration your engine is working harder and may cause the temp to go up slightly but, not much and, it should return to normal pretty quickly. If your temp is going up a lot and stays up you probably have a cooling system problem. First check to make sure you antifreeze level is correct. If not add coolant. If the problem persists you may have a stuck thermostat, a fan not coming on or worse case a blown head gasket.
What needle do you use in a rotax max?
Usually, within a standard Dellorto carburettor (With a 12.5 or 8.5 Venturi) , for a FR125 Rotax Max engine, a K98 or K27 needle will be used. The needles can be determined from each other due to the amount of tapering on it. A K98 has very little tapering, which creates a leaner fuel/air mixture, which improves acceleration, however using a K98 needle has a negative effect on the higher rev range (around 12,000+ rpm), as often not enough fuel reaches the cylinder, and you get a "coughing" or "popping" effect. On the other hand, using a K27 means that the needle has a much higher taper to it, causing more fuel to pass, which creates a richer fuel/air ratio, reducing acceleration, but improving high rev performance. Therefore we can conclude that the K27 needle is preferable at higher speed tracks, whilst lower speed tracks will be best suited by a K98 needle.
What is the difference between a hypertonic needle and a hypotonic needle?
A hypotonic needle is a needle that is a non coring needle. A hypertonic needle is a coring needle. Both of these needles are used in IV's with a hypotonic needle used for hypotonic solutions.
How are the rear disc brake pads on a 1994 Nissan Maxima changed?
the rear brakes have a 4 slotted piston that needs to be turned clockwise to retact piston back into caliper there is a special tool available at local autoparts store or you can try needle nose pliers.
What is a teasing needle?
a teasing needle is a needle that is use when dissecting something
What needle uses no thread?
A hypodermic needle. a record player needle
