0
What else can I help you with?
What horsepower does a 24 valve cummins diesel make stock?
My 1998.5 24 valve with an automatic had 210 hp. This information can be found on the data plate located on the left front flat edge of the front gear housing.
1990 Oldsmobile Calais dies when put into any gear and rough idle?
its the kick down solenoid on the transmisson try replacing egr valve or pcv valve
Dies when put in gear 91 camaro?
Assuming your car has an automatic transmission, it could be the TCC (Torque Converter Clutch) solenoid.
Is manual gear better than automatic gear?
Yes, manual is better than automatic gears.
What could be wrong with an automatic transmission that wont change from 1st to 2nd gear until the transmission gets hot?
There's sludge or bits in the valve body.
How many liters of oil in automatic gear box?
how many liters of oil automatic gear box laguna 2
Are gears in motogp bikes automatic?
No the gear's are not automatic , It's manual meaning the rider has to constantly change the gear's himself .
What causes second gear to go bad in an automatic?
Typically, just age. Each gear of an automatic transmission is operated by one of a set of clutches or bands. When a band or clutch wears out that gear is through and the transmission will need to be rebuilt. The Valve Body controls pressures to different pistons in the transmission. At specific events the valve body causes pressure to be applied to the 2nd gear clutch piston and if the pressure is not sufficient the clutch may "slip", causing additional and premature wear. Driving a vehicle with insufficient ATF can also cause slipping and wear.
How can you control gear change in an automatic car?
There are some automatic gear buttons. You can change them by pushing or pulling the handle of the gear forward or backward next to the correct button.
What gear is over drive in an automatic transmission?
It is called the passing gear.
What does L in the automatic gear box mean?
Low Gear normally it means 1st gear
Kubota ZTR diesel lawnmower and it dies when I put in gear to mow Would you have any ideas to what I need to do?
Not to be funny, but are you sure the foot parking brake is disengaged before you you try to move the mower?
