Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?
That is referred to as "back dating" and it is illegal at the federal level.
i would like to remove the backseat from my 1992 chevy cavalier
yes it does and depending on the engine some have more then one
its located at the rear of the engine (center) attached to the block
Usually in housing at engine end of upper radiator hose
Knowing the firing order of a cars engine can help diagnose car problems. The firing order for a 1992 Chevy Cavalier is 1-2-3-4-5-6.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
The directional flasher for a 1992 Chevy Cavalier is under the dash. It is mounted on the drivers side, beside of the steering column.
this question is very simple. Buy a owner manual for your car.
No it will not
It is in the fuel tank.
You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.
Go to the auto zone for parts and instructions
No, the 1992 Chevy 350 (5.7L) V8 is not a Vortec engine.
try your chev dealer and they should be free
In the center console, below the trap door.
Its on the firewall side of engine between transmission and engine just below the ignition coil packs one of the wire connectors from ignition module go to crankshaft position sensor
Cut the engine capartment out so it fits
It depends on which engine you have. V6 1-6-5-4-3-2 if it's a 4 cyl 1-3-4-2.
if this is anything like my 96 cavalier engine, it should be the left most cylinder as you look down on the engine, probable firing order would be 1, 3, 2, 4     front of car
under the engine