One or more of the gauges is out of the safe range. Could be due to over/under charging, low oil pressure, or an engine overheat.
a 2000 dodge ram 1500 the check engine light is on and the code says torque converter and clutch and overdrive solenoid. what do you think that the problem is?
There is a major communcaion problem between the computers on your truck. You will need to have it brought to a qualified repair shop. You can not diagnose this problem without a scan tool.
you need a new battery.
Check your fuses in your fuse block you should have a fuse that says "gauges". If you fuses check good take it to a mechanic shop.
Check the fuse. It says [guages]
My book says it's an emmissions problem and most likely the catalytic converter. Answer. There are pages and pages of causes for a check engine light. You need to have it checked for codes.
Check the oil cap. If its doesn't say, use 5w30If it says 5w20, use 5w20.Check the oil cap. If its doesn't say, use 5w30If it says 5w20, use 5w20.
it is the pastic push button inside of the door jam,when it is pushed IN the light goes off,OUT the light comes ON.
Unplug the coolant temp sensor and check what the gauge says...If it falls to cold, then the sensor is at fault. If it stays, then the gauge is either faulty or the contact points on the back of the gauges need to be cleaned... Unplug the coolant temp sensor and check what the gauge says...If it falls to cold, then the sensor is at fault. If it stays, then the gauge is either faulty or the contact points on the back of the gauges need to be cleaned...
That's what Patches says in the movie Dodgeball.
bad sensor
coolant temp sensor,does just what it says,it relays your coolant temp to gauges!