wrong filter with wrong thread pattern.
The blow-by filter on a 22 hp Briggs and Stratton engine is typically located near the crankcase. It is designed to capture and filter the gases that escape from the crankcase during operation. To find it, look for a small cylindrical or rectangular component connected to the engine's ventilation system. Always consult the engine's manual for specific details regarding the location and maintenance of the blow-by filter.
Chances are that there is a rubber O ring stuck in the channel the filter seats into. Remove the filter, take a scribe or something like a scribe and make sure there isn't an old O ring stuck up there.
breather tube from crankcase or valve cover brings blow-by to the air cleaner to reburn. excessive blow by will be heavy with oil in the air.
Wrong size filter for the engine, filter too tight or too loose, filter has a hole in it, or gasket not oiled before installation thus causing it to leak. The old gasket could have been left on the engine thus causing a leak with 2 gaskets installed.
your question is a bit ambiguous if you are talking about he engine oil filter it has nothing to do with the transmission do NOT put automatic transmission oil in the engine you will blow the engine
How do you blow a engine turbo.
No, the type air filter you use will have no detrimental effect on the head gasket. Head gaskets normally blow due to engine overheating.
the fuel filter is located on the right side on the passenger side its this little metal thing looks grey and has two hoses one on top of it and one on the bottom of it and this ring holding it with one screw this is how u check it if it still works take it out of the car then drain all of the gas out of it then blow thru it the air u blow thru it should blow right thru if not u have to replace the fuel filter this filter is cheap its like 8 dollars at auto zone
Well if its clogged then i say you need to get it fixed!, it could blow!!! It could blow because of the pressure build up in side
It's caused by engine blow by, there should be a filter in the housing that you can change. It's usually located on the side of the housing and it should have a hose running to the valve cover.
225 slant six engine? Could be a leaky oil pressure sending unit located just below the oil filter.
Blow oil filter? Pressure relief valve frozen? Engine seal? Oil pan gasket?