check your rear light bulbs. it is a two filament light and one is burned out.
From 1995 to 2001 Ford Explorer 4 doors it is a rotary dial on the left side of the CENTER STACK of the dash. From 2002 to 2005 Ford Explorer 4 doors , there are 3 vertical push buttons on the right side of the CENTER STACK of the dash From 2006 on, Ford Explorer 4 doors, there are 3 horizontal push buttons on the CENTER STACK of the dash located above the heater/ air conditioning selector dial. (Helpfull)
check the brake light switch above the brake pedal
The switch is on the roof, above the center rear-view mirror. It's a simple rocker switch.
one of them is that the steroscope lights from above the specimen and the microscope lights from below. one of them is that the steroscope lights from above the specimen and the microscope lights from below. one of them is that the steroscope lights from above the specimen and the microscope lights from below.
The Eddie Bauer is one trim level above the XLT Explorer
Jms:1:17: Every good gift and every perfect gift is from above, and cometh down from the Father of lights, with whom is no variableness, neither shadow of turning.
The candle that lights the others is typically referred to as the "leader" or the "guiding light." This person sets the example and inspires others to follow suit.
above the radio. above the air vents.
There are torx head nuts above the lights probably accessable through holes on the top of the grill area. Center torx nut controls up/down and the outside torx, above either headlight, controls side to side adjustment.
On my 1995 Ford Explorer , to lower the spare tire , I open the rear liftgate and the crank hole is just above the rear bumper in the center of the vehicle ( see if your 1994 is the same )
Above the brake pedal. If your main brake lights dont work but your third center brake light does, then the brake light switch is not the problem. Its is the turn signal switch.
remove the 2 screws above headlights that you see when you lift the hood...then push whole assembly towards the center of the car to release clips. housing will come out then you can change bulb