Trouble code P0572 means:Cruise control/brake switch A circuit low
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
The engine oil is overfilled.
The check engine light does not come on when an oil change is due. The check engine light is for an emissions related failure. It is reset with a scan tool after the fault is repaired.
That is the same as the check engine light. See related questions below.
If it is a new generation hemi (5.7, 6.1) it will come on because these are not flex-fuel vehicles.
The engine check light on Chrysler town & country come on only when there is problem with any sensor Mal function which set off the engine check light. To reset this indication light read the OBD code and correct the corresponding problem. Once the cause of problem is corrected, than only OBR scanner will reset this service engine light can be reset.
It comes on whenever a failure is detected, not at specific mileage.
A scan tool is required to read the trouble codes.
Engine overheat, low oil pressure, or alternator voltage.
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
It comes on when a malfunction has been detected by the engine computer. You need to have the codes read to know possible causes.
No. The check engine light comes on when the computer has detected a malfunction and set a code.