answersLogoWhite

0


Best Answer

If one side is lower than the other you probably have a weak or broken spring or torsion rod.

User Avatar

Wiki User

โˆ™ 2006-03-26 04:30:58
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your front end of your truck lean to the left?
Write your answer...
Submit
Related questions

What does it when dream of a front end of a red front end truck with chome?

It means you have a fear of heights.


Why does your truck leaning to the right?

A truck may be leaning to the right because it needs a front end alignment. Getting this simple tune-up performed will have the truck driving straight, instead of leaning to the left or right.


Where is a pumpkin on a Ford truck?

the rear end of the the truck!! there's one on the front if it's 4X4


Where is the oil filter on a 2006 chev Colorado truck?

It is mounted vertically (straight up and down) on the passenger side of the truck in front of the front end cross beam.


What is a Cali lift?

It is when you put a lift kit only on the front end of your truck or SUV.


What is the name of the 80s movie about a monster truck with a combine front end?

Maximum Overdrive?


What are front-end digits?

The entire number to the left of the decimal.Example:567.345567 is the front end number


Do you have to take off front end of truck to remove v-10 ford engine?

to remove a 6.8 v10 from a f350 2003 do you have to remove front end


Left Front wheel knocking noise when turn right?

Worn front axle and/or front end component.


Front end vibration and pulling to the left?

alignment and balancing


Where is the front driveshaft on a 1995 ford explorer?

It connects to the transfer case just behind the transmission, and at the other end connects to the front differential, in between the front wheels. The front driveshaft is on the driver's side of the truck, about 1 1/2 feet from the center of the truck.


Where is the bell housing on 1999 dodge ram truck 5.2L?

The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.


Where can you find an exploded schematic view drawing of a 2003 Dodge truck front end?

You can find an exploded schematic view drawing of a 2003 Dodge truck front end online at places like Ram ForumZ and Diesel Place. You can also find this expanded version of the schematic on Diesel Truck Resource online.


Can a one ton tow truck pick up a semi not legally not safely just can it do it the front end of the semi with out the front end of the one ton coming up?

Sure, it can be done.


What is the proper brake bleeding procedure for a 2001 Pontiac Grand am?

Start at right rear, then left rear, right front, and end at left front.


A parts diagram for the front end of a 1997 Ford Ranger 2 Wheel drive truck?

yes


Where are the shocks located from a Chevy truck S10?

Right behind the a arm in the front on the back on the rear end


What are the names on the front end suspension of a 1994 ford ranger xlt?

To the best of my knowledge this truck uses the front suspension called "Ford twin I-beam front suspension."


Where is the oil filter on a Chevy Colorado?

It is mounted vertically (straight up and down) on the passenger side of the truck in front of the front end cross beam.


What gear oil does a dodge 1500 truck front end and transfer case take?

Front axle is 75w90 Trasnfer case is ATF+4


Howling front end on 96 Chevy pickup?

Need to check left and right front wheel bearings.


What is z height on a truck?

The Z height measurement determines the proper ride height for the front end of the vehicle.


Can worn shocks cause a vibration in the front end of a truck?

Vibration, no but excessive bounce or wheel hop, yes.


Why does your Dodge truck have a bad vibration in the front end when you hit a bump?

Upper ball joints need replaced


What causes a Loud roaring noise left front end?

Wheel bearing