System airbound and needs to be purged
Not needed as the thermostat is on top of the engine on the right.
In front of the engine, down in the "V".
The thermostat at the engine in a 2000 Mercury Villager is located Êon the right passenger side near the middle. You should look for the jiggle valve on the thermostat that should be facing up.
On the front of the engine in the center of the "V".
The thermostat at the engine in a 2000 Mercury Villager is located Êon the right passenger side near the middle. You should look for the jiggle valve on the thermostat that should be facing up.
The bulb end goes toward the engine.
Your 1996 Mercury Villager minivan with the 3.0 L - SOHC V6 engine is designed to use The Ford Motorcraft RT 1170 thermostat ( 190 degrees F / 88 degrees C )
At the front of the engine under the housing that attaches to the coolant crossover tube assembly.
On a 1997 Mercury Villager, the thermostat is typically located on the engine, near the top of the engine block, where the upper radiator hose connects to the engine. To replace it, first ensure the engine is cool, then drain the coolant and remove the upper radiator hose. Next, unbolt the thermostat housing, take out the old thermostat, clean the mating surfaces, install the new thermostat with the correct orientation (usually with the spring side facing the engine), reattach the housing, and refill the coolant.
No, the 3.0 V6 in a 1993 Mercury Villager is NOT and interference engine.
Yes, exactly the same.
by da engine