0
What else can I help you with?
How do you convert a olds 5.7 diesel engine to gas?
Easy...you take out the old diesel engine, drop a gasser in. Not rocket science
Is it normal for the idle speed of a diesel engine to go up to 1100rpm when cold then drop to 800rpm after 5 mins?
NO that's bad
How do I change the fuel pump on a 2000 Ford F250?
Answergasoline or diesel engine? Gas V10You have to drop the fuel tank out of the vehicle to change the fuel pump. It is located in the fuel tank
What damage does ether do to a diesel engine?
Destroys push rods, valves, rocker arms, and pistons if valves drop into cylinders, DO NOT EVER use ether!
What is the weight of the GM 6.5 diesel engine?
you would not want to drop one on your foot that's for sure. But around 900 to 1100 lbs depending on dressed or not.
What will happen if on a see saw one child gets up suddenly?
The remaining child will suddenly drop to the ground.
Why would my fuel mileage drop suddenly with my f-350 7.3 powerstroke diesel?
You could have bad injectors or glow plugs. It is hard to say without more information. Injectors would be the first thing I would have checked.
Can a small amount of water in Chevrolet 454 engine oil hurt the engine?
Not sure what a small amount of water is, a drop? A couple ounces? A pint? Anything more than a couple drops in the crankcase wouldn't be healthy for the engine.
Would it be possible to drop a 1.9 Liter Turbo diesel Volkswagen engine into a 2005 ford ranger 2.3 Liter 4-cylinder?
a little cut and weld, anythings possible ;)
You put E85 in diesel F350 what do you do?
Drop tank and remove all the fuel. Do not run the engine off that tank. If you have dual tanks, use the other tank until the e85 is removed.
Do you have to pull the trans axle to drop the small block on a 2.4L 2005 Sebring?
The engine is removed out the bottom with the transmission if that is what you are asking.
Why does the well pump pressure drop suddenly?
The well pump pressure may drop suddenly due to a variety of reasons, such as a leak in the system, a malfunctioning pressure switch, a clogged filter, or a drop in the water table. It is important to investigate the cause promptly to prevent further damage to the well system.
