0
To keep things simple I would remove the air cleaner housing the entire unit.Just note the several vacumm lines you will disconnect locations.And clean the carburetor extremely well with carburetor cleaner inside the part and use some brake cleaner on the outside(Just use the brake cleaner only on the linkage).I would use some liquid wrench to lubricate the moving parts on the outside of the carburetor only.Liquid wrench comes in a variety of products use the penetrating version has a green label and sold at Walmart for sure.Unless the truck needs a good tune up,and the egr removed and cleaned and the exhuast system needs work like the exhuast collector or catatlyitic convertor try the above first.I would however recommend a new set of plugs,wires,cap/rotor button,change your oil and filter and replace the fuel filter,air filter,pcv valve and clean the egr valve under the carburetor with a tooth brush and same chemical and even the oxygen sensor to really clear the system.OK I have owned my 1987 b2200 since new and know this truck.
What else can I help you with?
What is the horsepower of a Mazda b2200 diesel engine?
A Mazda B2200 engine with carburetor has 85 horsepower, and with fuel-injection has 105 horsepower.
How do you install a weber carburetor on a 1992 Mazda B2200?
Attached is a modified version of Weber's instructions specifically for the B2200 and B2000. Kyrasis6 Owner of Mazdatruckin.com
Can you put a 2.8L Nissan engine in a 1991 Mazda B2200 pickup?
no
Am getting fuel in the crank case of a 1992 Mazda B2200 Pickup Is there any way to adjust the carburetor so this won't happen or must it be replaced?
If it haas a mechanical fuel pump--diaphram in same may be defective and pumping fuel directly into crankcase
Torque specs for head bolts on a 1990 Mazda b2200 pickup truck?
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
Where is the location of the water pump on a 1990 Mazda B2200 pickup?
behind the radiator,in the middle of the engine
What could cause hesitation when stepping on accelerator pedal in a 1998 Mazda B2200 pickup?
My 89 B2200 does this. Its like there is a dead spot in the acceleration. It is because the accelerator pump is leaking.
How much pressure on electric fuel injection fuel pump for 1992 b2200 Mazda pickup?
92 b2200 ,fuel injection psi should be 38 to 46 psi
How do you adjust the choke on a Mazda pickup on a b2200 series 1988 mechanical carburetor?
When engine is cold loosen screws on choke cover, or drill out rivets. Hold throttle part way open, then turn the cover until the choke opens, then slowly turn the choke cover the opposite direction until the choke closes all the way. Mark the cover and tighten or install new rivets and you are done. Good luck Jerry
Where is the MAP sensor on a 1990 Mazda B2200?
The map sensor is on the air intake line to the throttle body....
How do you install a Weber carburetor on a Mazda b2200?
Attached is a link with instructions to install a weber on a Mazda B2200 or B2000. These instructions have been modified from the original to be more specific to you're application. Kyrasis6 Owner of Mazdatruckin.com
Is there a 17in chrome spoke wheel to fit a 6x139.7 pattern lowered 1990 B2200 Mazda pickup?
-
