answersLogoWhite

0


Best Answer

you have to turn them not push them

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why don't my car air conditioner direction knob works?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the air conditioner knob control on my '03 Trailblazer only works on 5?

switch, relay or blower motor problem as a guess.


How do you remove the gear knob on Citroen ZX?

dont


What direction must the coarse adjustment knob be moved to raise the body tube?

Clockwise


How do you change a shifter knob on a 1996 impala?

you dont, you should keep it classic


How do you stop an air hog helicopter from spinning?

Trim it by turning the trim knob in the opposite direction that it is spinning


How do you impress a girl to kiss you?

dont be a knob and always wear a smile :) or just ask...


Where do you put a brodie knob on a steering wheel?

There is no set place to install the knob. Install it where it works for you. The most common location is at 10 o'clock or 2 o'clock. Know that it is illegal in most states.


What direction must the coarse adjustment knob be moved to raise the body tube move?

slowy going up


How do you remove stick shift knob on 2001 S10 Chevy?

This is tricky, there should be a nut at the bottom of the knob. Turn this nut to the right, this should leave room to hold it tight while you turn the knob left. This is done while sitting correctly in the seat(for direction purposes). The knob should come off with a little elbow grease.


Why does my air conditioner knob control on my 2000 Chevy Impala only work on 5?

you need to repleace the blower motor resistor under the das on the passenger side


If your hand were negatively charged and you touched a neutral doorknob which direction would negative charges move?

Hand to door knob


How do you remove a gear knob in a v reg vauxhall corsa lift reverse?

You can first try to twist it in an anticlockwise direction and then pull but if that doesnt work make a cut around the material that bonds the knob to the lever. You can then pull it out.