There is no set place to install the knob. Install it where it works for you. The most common location is at 10 o'clock or 2 o'clock. Know that it is illegal in most states.
try and put your key and shack the steering wheel
A person removes the steering wheel with a steering wheel puller, after removing the airbag to the car. Then they put the new steering wheel on the car, after aligning it correctly.
put the key in the ignition and turn the steering wheel and the key at the say time (turn the steering wheel to the left)
Put the key in and move the steering wheel until the key can turn
Yes, one can put a new steering wheel and column in a car. If it is a DIY project, one must be very careful to reconnect everything carefully so the steering column does not jam.
The steering wheel is used to aim the car in the direction that you want to go. Simply put, it is used to steer the car.
it should be on the centre of the steering wheel unless someone has put an after market steering wheel on without the horn.
go online you can buy any boss kits and fit any steering wheel you wish
There is a knob on the left side of the steering wheel , well that is with my C6 anyways. Jump over to Smokinvette.com and put this question in the C5 section and you will be sure to get the right answer! Good luck!
wheel and axleA doorknob is a lever.Some of the door knobs are made up of wheel and axle.A door knob is a wheel and axle. It has a wheel that is fastened to an axle
As you drive the steering tightens. You may need to check your power-steering fluid or put air in your tires.
To put a Chevy Trailblazer into four wheel driver, locate the four wheel drive component below the instrument panel. While the car is in drive, move the knob into the desired four-wheel drive position.