To avoid dangerous tension in the glass.
i dont know either...
What is the answer, can you pls help me 😭😩😞😣😫😕
A boiling tube is used for boiling a liquid in
1. The test tube does not have to be full.2. The test tube should not be too close to the flame.3. It is recommended to work in one laboratory fumehood.
when was test tube first made,when and who?
i dont know either...
heat the test tube in inclined position..alcohol is a hydrocarbon
we use test tube to hold chemicals and heat and chemicals.
the proper way to heat a liquid in a test tube is by putting it in open flame.
IN Physics wards:Why do we heat test tube in a water bath and not directly over a flame?
Heat is transferred by three methods; Convection, conduction or radiation. If the test tube is touching anything (such as the stand or a table) then heat can be lost through conduction; the hot test tube transfers heat to the stand. You can reduce this heat loss by using a material such as wood that does not conduct heat well. The air around the test tube will be heated, and the hot air rises away, allowing cold air to flow around the test tube. The new cold air becomes heated, and rises away and.... This is called convection. Even in a vacuum, the heat of the test tube will be lost through radiation, as the heat of the test tube is transferred to nearby objects. If you put your hand near the test tube, you can feel the heat even without touching it. This is how the heat from the Sun reaches the Earth, even though we're not touching the sun and the 93 million miles of space between us and it is a pretty good vacuum.
What is the answer, can you pls help me 😭😩😞😣😫😕
i dont know what do, think
IN Physics wards:Why do we heat test tube in a water bath and not directly over a flame?
Place the ice cube under the wire gauze at the bottom of the test tube. Heat the mouth of the test tube now you can observe the ice cube melting slowly because the heat at the top of the test tube won't move to the bottom but moves higher.
You boil some water and put the test tube in and its heated up but you don't have to worry about a flame. You boil some water and put the test tube in and its heated up but you don't have to worry about a flame. To heat a test tube you simply use a Bunsen burner. Make sure you use pliers to hold it with though because it will get very hot. Also you can change the heat of the Bunsen burner by switching it to the blue flame. you always hold it away from you and your lab partner. heat it sideways and slowly run it through the flame to distribute the heat evenly.
When look to buy a test tube, one should consider the purpose of the test tube. If heat is not an issue for the user, then a plastic one is more than satisfactory. However, the standard lab test tube is primarily made of glass.