Check the fuse. Then check the wiring.
Are you sure you need the fuse for the cruise control. My cruise control wasn't working, neither were my brake lights. All 7 bulbs were burnt out. When the brake lights were replaced the cruise control worked.
There are two. The brake light switch and the cruise control cut off switch. You are probably talking about the cruise control cut off switch. When you depress the brake pedal, the brake lights come on and the cruise control stops. Hope this helps
Probably a brake light switch problem. May be able to adjust, or may need to replace. I just replaced the brake light switch in my 1998 Mazda Protege LX and the problem came back. I believe the cruise control could be shorting out the brake light switch.
Start by removing the connections for the cruise control and brake lights, then remove the bolt that holds the switch to the brake pedal. Once the brake pedal is loose the switch is held on the brake pushrod by a bushing with nylon retaining washers. Carefully remove one washer and slide the bushing out, the switch can now be removed from the pushrod. Installation is the reverse; line up the hole on the switch with the hole on the pushrod, make sure the tabs for the cruise control and brake lights are facing properly. Reinstall the bushing and replace the other nylon washer, replace the bolt and tighten. Lastly connect the brake lights and cruise control.
Brake switch needs replaced.
Common issue...if the brake light swith is not working; the cruise control will not engage and your brake lights will not go on. replacing switch is easy and inexpensive...its located in the upper part of the brake pedal.
Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
The turn signal switch overrides the brake light circuit while the turn signals are on. If the switch is damaged or worn out the brake lights won't work.
Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.
check fuses & brake lights switch located on brake pedal
The BOO (Brake On/Off) Switch may need to be replaced. If it is bad, it would cause the brake lights to NOT illuminate when the brake pedal is applied.