0
Why has the driver side's headlight's high beam stopped working?
Wiki User
∙ 14y ago
The headlight has two filaments. One for the high beam and one for the low beam. The most likely reason the high beam is out is because the high beam filament is broken. Replace the bulb and it should fix it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is wrong with a '94 Pontiac Transport if the windows stopped working on both sides the switches do not do anything?
check the fuses
How do you adjust the headlights on a 2000 Buick Regal LS to see more distance on the road?
I like to get on a dark road and adjust them with the screws on top and sides of the lights but don't blind the driver comming at you.
96 buick century speedometer stopped working how can you fix it?
Unhook both sides of battery and wait 1 minute, this will reset reset the computer to default.
Why on your 1996 Dodge Stealth and your window and power locks on both sides stopped working How do you fix this Is there some kind of security equipped causing this?
This happened on my 93. The wires at the clip between the door and the body when you open the driver door are broken. Everyone seems afraid to attempt a repair. Might have to replace main wire harness.
How do you remove headlights on 1998 mustang?
Pop the hood and behind the headlights there are 3 black washers on each headlight. You must squeeze the sides of the washers in and then the headlight slides right out.
How do you adjust headlight on 94 Ford Probe gt?
When you have the headlights flipped up then you will see 2 holes one on the top and one on the sides. There is a Phillips screw in there that you turn to adjust the headlights.
Is the driver side facing the car the right side?
If the car is designed to be driven on the right side of the road, when you stand in front of the car and look at the driver, the driver will be on your right. Left and right sides of the car are determined by sitting in the driver seat. I usually just refer to the car sides as driver side or passenger side so as not to confuse anyone.
How do you adjust the low beam headlights on a 2004 Mini with standard lights not auto adjusting which screws do you turn - hard to see them?
The adjusting screws for the low beam headlights on a 2004 Mini are on the sides of the headlights. There is a screw on the side for adjusting from one side to the other. There is also a screw on the bottom for adjusting up or down.
How do you adjust the headlights on a Buick Park Avenue?
On older models (ex my 91) there are Phillips screws on the sides on the headlights that you turn to adjust the headlights (either up or down or left or right) on newer cars (ex my 98) there are levels built right into the headlight assembly, park the car dead level with a half tank of gas and like up the marks by turning the screws that adjust the headlights
How do you remove the driver side door panel of a 90 olds regency?
You will need a torx head screw driver and a Phillips screw driver, remove the screws around the closing handle and the opening handle, then gently pry at the bottom of the panel to pop the fasteners loose working your way up the sides, lift the panel out of the the window slot and over the door opening handle.
Would a cancel switch make the gauges on your 1987 samurai stop working?
If the Gauges on your instrument panel have stopped working you may have had a voltage converter stop working. This device mounted to the rear of your instrument panel converts the voltage from your alternator to the voltage that your gauges run off of. You can check the fuses with a multimeter and see if both sides have voltage showing, if so then see about replacing the voltage converter.
When can you use pythagorean theorem?
When working out the sides of a right angle triangle.
