0
Why is a lap joint better than a butt joint for brazing purpose?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why are rebated joints stronger then butt joints?
The rebated joint has a better holding strenght compared to the butt joint. Otherwise look at this website:http://www.woodworkbasics.com/rebate-joint.html
Is a butt joint stronger then a finger joint?
yes it is alot stronger than a finger joint as it is tightly compact pressed together(:
What purpose does a big butt mean on African America?
Well the purpose mean big butt, nice assets, banging curves and in bed, better sensation if u know what I mean....wink wink
What are the different types of welding joints?
One of them is the 'butt joint', where two pieces of metal are simply butted together. Another is the 'lap joint'. Other types include, but are not limited to: the flange joint, the corner joint, and the cruciform joint. See the related Wikipedia link listed below for more information, including diagrams.
What is a butt made for?
BUTT: A container and unit of measure for wine Butt: A type of joint Butt: Archery target There are different answers for these and more types of Butt.
3 types of piston ring ends?
a) lap joint b) angled joint c) butt joint
Can you tell me names of 4 wood joints?
Butt joint Mortise and tenon Dovetail Corner joint finger joint
What is a butt joint?
Butt joints in furniture making is the joining of two pieces of wood, end to end without the assistance of a joining device such as fingers, dovetails, or box joining. Generally, the use of dowels or biscuits is encouraged to improve the strength of the joint. A butt joint without such reinforcement devices is the weakest form of joint, and may fail if stressed.
What are wood joints called in technology?
wood joints, but their are different types, butt joint, finget joint, dovetail joint etc.
What are the different types of wood joints and their uses?
butt joint
How do you install butt-joint glazing for glass panels?
I need an answer
Why are grooved butt joints better for welding thick plates then square butt joints?
The square butt jointis used primarily for metals that are 3/16 inch or less in thickness. The joint is reasonably strong, but its use is not recommended when the metals are subject to fatigue or impact loads. When you are welding metals greater than 3/16 inch in thickness, it is often necessary to use a grooved butt joint. The purpose of grooving is to give the joint the required strength. When you are using a grooved joint, it is important that the groove angle is sufficient to allow the electrode into the joint; otherwise, the weld will lack penetration and may crack. However, you also should avoid excess beveling because this wastes both weld metal and time. Depending on the thickness of the base metal, the joint is either single-grooved (grooved on one side only) or double-grooved (grooved on both sides). As a welder, you primarily use the single-V and double-V grooved joints.
