most likely a bad wire get a new one
if a cylinder is not firing there will be no spark at the spark plug. Carefully twist as you pull the ignition wire out and start the engine. when the wire gets close to the spark plug you should see an arc. This means the cylinder is firing
Yes
Bad spark plug? Bad plug wire? Do a compression test
firing order is 18436572
Change one wire at a time. Take the wire from the distributor then the spark plug end, replace with wire of same length. As you do this compare wire lengths and you will be able to change them without any trouble. BE SURE THE SPARK PLUG END BOTTOMS WHEN YOU INSTALL IT OR YOU WILL GET A MISS IN THE FIRING.
Your weed eater spark plug may not be firing due to issues such as a dirty or faulty spark plug, a disconnected or damaged spark plug wire, or a problem with the ignition system. It is important to check and replace the spark plug if needed, ensure the spark plug wire is connected properly, and troubleshoot the ignition system to resolve the issue.
Bad distributor cap, plug wire, or spark plug.
you may have plug wires on wrong plugs. you need to get the firing order, find number 1 on distibutor, conenect plug wire from there to number 1 plug . then repeat this using the correct firing order and doing one plug wire at a time
A banana plug is a single-wire male component of a banana connector.
#1 (From furthest left plug) - Longest wire == ==
A plug not firing for some reason. this may be do to bad wires, insulation cracks cause spark to jump from wire to wire, or wire to ground.
It is a single cylinder engine with one spark plug so there is no firing order.