answersLogoWhite

0

Back pressure is required in the turn to keep the nose from dropping. That will keep the plane flying level.

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

How do you adjust the pressure domestic water valves?

By reading and following manufacturers directions of course


Does a 2001 doge neon have a low oil switch?

It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.


What happens to the efficiency of car engine if the muffler is removed?

Any engine needs back pressure to run efficiently. That is what the mufflers do, they create back pressure. So, by removing the muffler(s), you have stopped the back pressure, which in turn causes the engine not to run efficiently.


How can hot air make the Fan Blades Turn?

Hot air can make fan blades turn by creating a pressure difference between the front and back of the blades. When air is heated, it expands and becomes less dense, creating a lower pressure behind the blades. The higher pressure in front of the blades then pushes the blades in the direction of the lower pressure, causing them to turn.


How do I install a pressure tank?

To install a pressure tank, first turn off the power to the pump. Then, connect the tank to the water supply line and ensure it is level. Next, adjust the air pressure in the tank to the recommended level. Finally, turn the power back on and check for leaks.


Do you have to worry about not having enough back pressure if you want to remove your muffler on your 2000 Dodge Neon?

Yes a lack of back pressure can cause the oxygen sensors to read improperly, which would turn the check engine light on.


When the maximum allowable water pressure within a building is exceeded a is required?

pressure reducing valve is required.


How do you turn on toes snowboarding?

put more pressure on front foot and back foot is easier to whip around to steer.


What determine residential water well pressure?

The pressure is determined by the "pressure switch" typically located at the pressure tank. The switch monitors system pressure and will turn the pump off when the water pressure reaches a predetermined level. As water is used - drawn off the pressure tank - the switch will turn the pump back on at a lower pressure. Switches are typically 30-50 or 40-60 (contacts closing at the lower pressure setting and opening at the higher setting).


Pressure switch adjustment?

This depends on what pressure control valve you have and the switch that comes with it. Some may be adjusted, others not, check for a small knob that you can check for pressure adjustment, best way to do this would be to open a tap (faucet) and then turn the adjustment knob down or up to the required pressure.


How do you get pressure back in clutch pedal it goes right to the floor and sticks?

turn your car on and pump the peddel with your hand till u get pressure then get a new clutch and master cylinder for the clutch


How do you check the Fuel Pressure Regulator on a 1997 S10 Blazer?

connect a fuel pressure gauge to the port at the back. turn key on and check for pressure,watch for pressure drop if it drops immediately regulator is leaking.on4.3 reulator is under upper intake plenum