answersLogoWhite

0


Best Answer

Hot water in the radiator is under pressure and can burn you.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

eugene makhomo

Lvl 2
1y ago

[object Object]

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is dangerous to remove the radiator cap of a car when the engine is still hot?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat located on a 1999 Lincoln Continental V8?

On a 1999 Lincoln continental the thermostat is located by following the lower radiator hose from the radiator to the engine. It is easily accessible from underneath on the front passenger side. Remove small over flow hose only their is no need to remove lower radiator hose and once you remove the two bolts the housing will come off with the lower radiator hose attached hose still attached.AnswerFollow lower radiator hose from radiator to engine on 1999 Lincoln Continental V8.


Where is the thermostat located on a 1998 Subaru Forester?

a prior response has explained your ? located in fitting where lower radiator hose connects to bottom of engine. engine water temp should be cooled before draining. to access need to drop plastic shroud under front of engine/radiator, then drain radiator into container, facilitate by opening vent on left side of radiator (has Philips screw cross), and remove radiator cap. from under car remove 2 bolts that hold fitting at end of lower radiator hose where connects to engine (caution - still some juice here). bend out of way to access the thermostat that will be pressed/wedged in seat with rubber o-ring (still more juice here).


In a 1999 chrysler sebring convertible does the engine come out the bottom or through the top?

If the tranny is removed from the bottom first, then you can remove the engine from the top after removing the front bumper cover, upper and lower radiator supports, radiator and condenser, and hood. Or, you could remove the tranny and engine from the bottom as a unit, but you'll still need to remove everything in front of the engine so that you can first move it forward about 8 to 10 inches so that the rear exhaust clears the rear crossover support (that has the power steering rack on it).


How do you remove the engine from a 1999 Taurus?

you can remove the engine from the top by leaving transmission still in car


What does a radiator hose do?

carries water from and to the engine to the radiator for cooling, there are 2 and contain hot water when the engine is running and will still be hot and pressurerised for an hour after the motor is shut off.


Replaced fans radiator sensor rfw engine light still on?

If an engine light is still on after replacing a fan's radiator sensor in a RFW engine the coolant sensor should also be checked. If the coolant sensor is bad it will send an error code to the car's computer.


Can you still drive a car w leaking radiator?

A car with a leaking radiator can be driven, but when the coolant leaks out, the engine will overheat and when the engine gets hot enough, it will seize-up, the car will stop, and the engine will have suffered severe damage.


When the engine has cooled off will you still have pressure from the radiator cap when you try to take the cap off?

no


Where is the thermostat on a 2002 elantra Hyundai?

on the drivers side of the engine. you need to remove air box then the hose that connects to thermostat. Still stumped? run your car until its at running temp. Then carefully touch radiator hoses. follow the colder hose to the engine and your there.


How do you get a 1996 Ford Explorer radiator completely out of the truck?

You'll also need to get a wrench to hold the fan while you remove the bolts that hold it onto the pulley because you have to take off the fan to get the radiator out. Well first you should drain the coolant/antifreeze. There is a small faucet on the passenger side. Make sure that the engine is cold so you can remove the cap and also so you can hold the radiator. Once the coolant stops dropping remove the upper hose from the engine and then the lower hose that goes to the engine. Be careful with the lower hose since is lower that the faucet and still has coolant. Then remove the pipes from the transmission using a 3/8 wrench, the lower one will spill some oil. After that just remove the fan cover and then the radiator itself. There are only bolts on top once removed them just pull up.


How do you replace coolant on a Chrysler voyager 1999?

First, remove the radiator cap. If car is still warm, turn radiator cap about 1/4 turn to relieve the pressure. Then, I find it much easier to remove the lower radiator hose from the radiator. It's much quicker than draining it from the petcock.


How do you unplug radiator plug?

If you mean a freeze plug, that is usually in the engine block, not in the radiator. Maybe you mean a clogged radiator. If that is the case. First you would flush it out with water. You can remove the hose from the bottom. Then reattach the hose and add water and a chemical radiator flush product that you can buy from the auto supply store. Drive for about an hour of more. Then flush out the radiator again. Refill the radiator with water and see if your engine runs cool enough. If all that does still does not work go to a radiator shop and have them rod it out. If they can't do that, you may have to put in a new radiator. Good luck. One more thing. You may also want to check the thermostat.