So you don't break or bend the pins on the chip.
You don't want to bend the pins
You can bend (thus damaging) the pins on the underside of the processor
Processor pins, or in modern computers the pins in the sockets, are very delicate and easy to bend. If you insert the processor any way other than straight down, you will bend the pins and likely destroy either the processor or the motherboard, or both.
Because the pins on the bottom of the processor can be easily bent (assuming that this is a processor for a PGA (Pin Grid Array) or SPGA (Staggerd PGA) socket. It is worth noting though that a processor for a LGA (Land Grid Array) socket is not as susceptible to this as the there are lands or pads on the bottom of the processor instead of pins; the pins are in the socket. The book that asks this question assumes PGA. ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Very true BUT you can bend the lands in an LGA socket, rendering the socket hence the motherboard useless!
An ATM processor is an Automatic Teller Machine Processor, i.e. a machine that, when you insert a card, gives you means of exchange, or money.
If you are using XILINX FPGA, try to insert a Microblaze processor to control your ADC.
The "Insert Citation" button is typically found in a word processor program, such as Microsoft Word, within the "References" or "Citations" tab. It allows you to easily insert citations and manage references in your document following a specific citation style.
To lock one side of a sliding mirrored closet door, a person can insert something in the channel for the slide mechanism that will stop movement of the door. A screw will accomplish this if it is left only halfway screwed in.
if you have a rear sliding window use a table knife to jimmy the catch and if you're to big insert a kid
A dialog box will open allowing you to choose the amount of columns and rows you want to insert. You can also open the table shortcut menu.
To install a screen sliding door in your home, first measure the door frame to ensure a proper fit. Then, remove the existing door and frame if necessary. Install the bottom track, followed by the top track. Insert the door panels into the tracks and adjust for smooth sliding. Finally, secure the door in place and test its functionality.
To insert film into an Instax Mini camera, open the back cover of the camera by sliding the latch. Take out the film cartridge from its packaging and insert it into the camera with the yellow mark aligned with the yellow mark inside the camera. Close the back cover and press the shutter button to advance the film to the first frame.