Actually, it should decrease in size. The volume of a gas is directly proportional to the temperature of a gas (measured in Kelvin). Therefore if you inflate a balloon with your warm breath and then cool it down with cold water, the balloon will shrink, not increase in size.
See the Related Questions for more information about the effect of temperature on gases.
When particles are heated up the particles expand and when it is cooled down they contract, so on a hot day the balloon's particles will expand and when the temperature comes down the particles will contract.
5.98kPA
When the temperature is colder the particles in the balloon travel slower, making the balloon not able to increase in size it decreases.When the temperature is hot it allows the balloon to expand because the particles in the balloon are moving rapidly. in conclusion the the cold makes the balloon decrease in size and the heat allows it to expand.
Yes this can be done but the process would be really slow. You can try adding some yeast to hydrogen peroxide and let the balloon be tied to the bottle containing that mixture. After couple of hours you will have inflated balloon.
When the vinegar mixes with baking soda it produces a gas that will cause the balloon to expand
When an inflated balloon is exposed to cold air, provided pressure is constant, the volume will decrease. Bring the balloon back to a warmer spot, and the gas gains kinetic energy from the warm air, and the balloon will plump back up.
As height is gained the outside air pressure on the balloon is reduced. This reduction allows the gas inside the balloon to expand.
the heat caused the air inside to expand.
The pressure in the balloon stays the same, but the pressure outside drops as the altitude increases. And as the outside pressure drops, the balloon expands.
Since there is no external pressure to counteract the internal gas pressure, the gas would expand until the balloon burst.
Because as the balloon is heated, the gases on the inside of the balloon begin to expand and press out on the walls of balloon. If a balloon is refridgerated, the opposite is true: the gases on the inside of the balloon will begin to contract, causing the balloon to shrink.
There is not a PICC line with an inflated balloon for placement.
You did
If you put an inflated balloon in a jar and then remove the air from the jar the balloon will expand. Perhaps to the point of bursting, or to the point where it coats the entire inner surface of the jar.
There is no difference at all if the balloon is not inflated or inflated with air.
The elastic contraction of the rubber in the balloon's membrane causes the pressure in the air inside an inflated balloon. When you inflate a balloon, you have to expand the latex of the balloon, which stretches when filled with air from a pressure of 760 mm Hg to as high as 840 (about 10% higher than standard atmospheric pressure). If you inflate a non-elastic mylar balloon, it takes no effort: the air inside is at the same pressure as the air outside.
The volume of the balloon decreases
Helium goes into a balloon to make it float.