Want this question answered?
The rear speakers in a Toyota solara convertible, you must first remove the existing speakers by removing the cusions from the back of the seats and then accessing the main wire panel to discconect them.
I can only give you a partial answer. It will be one of the fuses in the fuse panel in the inside of the car. Is there a fuse layout on the back side of the puse panel cover? Owners manual, maybe. Sorry I could be of more help.
The information you're looking for (along with a diagram) is in your owners manual. Check pages 314 and 315. The dash light fuse is #31 on the fusebox. It's 10A and labeled "Panel." Cheers
I think you have to remove the back seat. There should be a service panel underneath the seat that will allow you access to the fuel pump.
Is it staying on because it needs an oil change ? Or oil needs topping up ? Or engine is over heating due to weak water pump ? If there are no problems other than the engine light staying on the bulb can be taken out but you'll need to take out the instrument panel to do so.
The boot light must be staying on.Check the switch.
How do you change the light bulbs in the instrument panel in 1998 Toyota corolla
Explanation of 2003 Toyota Corolla Dashboard
disconnect the battery, then drop the sterring column, remove the insterment panel and the bulbs will be on the back of the insterment panel
In a 1987 Toyota Camry (I think through like 1992), it's in the panel to the left of the driver's feet. There are two relays in that panel on mine, the rear is the Defogger, the Front one is the Taillight relay.
How do I replace the dash panel lights on a 2001 toyota sequoia?
This same answer was posted yesterday to the same question about an '05 Solara. The procedure is identical since they're both Gen 2 Solara's ('04-06) Tip: Download the factory service manual from Toyota and you'll have the full step by step explanation along with pictures. The best I can do here is give you the step by step as a cut/paste from the manual. Radio Receiver Assy Replacement. 1. Remove shift lever knob sub assembly 2. Remove console upper rear panel 3. Remove console panel upper 4. Remove instrument cluster finish panel center 5. Remove center cluster integration panel, remove four bolts. 6. Disconnect electrical connectors. 7. Disengage the 4 claws and remove the center cluster integration panel assembly. 8. Remove radio bracket #1 by removing 6 screws Voila, the radio is out! Assembly is reverse.