0
In an NPN transistor an emiter follower refers to an amplifier topology. The emiter follower configuration is when the emitter of a N-Type Bipolar Junction Transistor (BJT) is connected to the common point on a circuit (typically ground). This is not always the case, however, because many amplifier configuration exist.
What else can I help you with?
Why npn transistor is called emitter follower?
because one of the terminals is common for for both i/p and o/p
What is a npn transistor?
== ==
What are 2n2369 transistor?
What is a 2N2369 transistor.It's an npn switching transistor.
What is SL100?
It is an npn power transistor
Is BT169 a npn or pnp transistor?
BT169 is neither an NPN nor a PNP transistor. BT169 is a thyristor, otherwise known as a silicon controlled rectifier.
When an NPN transistor is saturated its Vce?
is zero
What are the similar transistor for 2SC2939 NPN?
2N2222
How do you convert npn signal to pnp signal?
To convert an NPN signal to a PNP signal, you can use an inverter circuit, typically implemented with a transistor or a logic gate. For a simple transistor-based solution, connect the NPN transistor's collector to the power supply, its emitter to the load, and the base to the NPN signal through a resistor. When the NPN is on (high signal), it will turn off the PNP transistor, resulting in a low output, and vice versa, effectively inverting the signal.
What is the difference between upstream and downstream in electrical network?
Generally upstream is closer to the positive (+) voltage source. In the case of an NPN transistor upstream of the transistor is the part of the circuit from (+) to the NPN collector pin. Downstream of the transistor is from the NPN emitter pin to the ground / sink / negative (-) terminal.
Why a transistor is called with BC547?
A small signal NPN transistor used for general purpose audio amplifiers and switching.
How do you know if a transistor is a PNP or an NPN?
To know if a transistor is PNP or an NPN,the following should be verified:For a PNP transistor, the base-collector junction is forward biased while the base-emitter junction is reversed biased.For an NPN transistor, the base-emitter junction is forward biased while the base -collector junction is reversed biased.
What are the majority carrier in the base region of npn transistor called?
In an NPN transistor, the majority carriers in the base region are called holes. The base is made of p-type material, which means it has an abundance of holes (positive charge carriers) compared to electrons. This allows for efficient charge transport when the transistor is in operation, facilitating the flow of current from the collector to the emitter.
